dig:smd
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
dig:smd [2013/03/10 15:42] – [Step 1: Getting Started with the 5V rail and the PWR LED] tobi | dig:smd [2024/02/29 07:28] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 54: | Line 54: | ||
- Be careful not to melt the plastic of the micro USB connector. | - Be careful not to melt the plastic of the micro USB connector. | ||
- Inspect the pins under the microscope to make sure they are all soldered nicely. It is easy to put too much solder, just start with a little bit and then add some more only if needed! | - Inspect the pins under the microscope to make sure they are all soldered nicely. It is easy to put too much solder, just start with a little bit and then add some more only if needed! | ||
- | - Below is an example of a micro USB header that is not properly soldered. Note how the left pin is not soldered. | + | - Below is an example of a micro USB header that is **not** properly soldered. Note how the left pin is not soldered. |
{{: | {{: |
dig/smd.txt · Last modified: 2024/02/29 07:28 by 127.0.0.1