dig:smd
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
| dig:smd [2013/03/10 15:42] – [Step 1: Getting Started with the 5V rail and the PWR LED] tobi | dig:smd [2013/03/10 15:48] – [Step 1: Getting Started with the 5V rail and the PWR LED] tobi | ||
|---|---|---|---|
| Line 54: | Line 54: | ||
| - Be careful not to melt the plastic of the micro USB connector. | - Be careful not to melt the plastic of the micro USB connector. | ||
| - Inspect the pins under the microscope to make sure they are all soldered nicely. It is easy to put too much solder, just start with a little bit and then add some more only if needed! | - Inspect the pins under the microscope to make sure they are all soldered nicely. It is easy to put too much solder, just start with a little bit and then add some more only if needed! | ||
| - | - Below is an example of a micro USB header that is not properly soldered. Note how the left pin is not soldered. | + | - Below is an example of a micro USB header that is **not** properly soldered. Note how the left pin is not soldered. |
| {{: | {{: | ||
dig/smd.txt · Last modified: 2024/02/29 07:28 by 127.0.0.1