dig:lab_5
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
dig:lab_5 [2011/04/04 14:39] – tobi | dig:lab_5 [2013/04/12 11:56] – tobi | ||
---|---|---|---|
Line 8: | Line 8: | ||
- Keep sensitive electrical nodes far away from the noisy digital servo control. | - Keep sensitive electrical nodes far away from the noisy digital servo control. | ||
- Place at least one bypass capacitor near the microphone preamplifier circuit. | - Place at least one bypass capacitor near the microphone preamplifier circuit. | ||
- | - Don't put components | + | - Don't put components |
+ | - Check your board against this [[https:// | ||
You may find it helpful to again scan the {{dig: | You may find it helpful to again scan the {{dig: | ||
Line 17: | Line 18: | ||
When you are finished with your board schematic and layout, send a zip/tgz archive of your design to [[tobi@ini.phys.ethz.ch? | When you are finished with your board schematic and layout, send a zip/tgz archive of your design to [[tobi@ini.phys.ethz.ch? | ||
- | |||
dig/lab_5.txt · Last modified: 2024/02/29 07:28 by 127.0.0.1