dig:lab_5
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
dig:lab_5 [2011/03/24 20:08] – tobi | dig:lab_5 [2013/04/12 11:56] – tobi | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Lab 5 ====== | ====== Lab 5 ====== | ||
- | In [[lab_4]] we drew the schematic of our board. Now let's do the layout of our PCB. Now we'll use the layout part of Eagle, along with perhaps the footprint editor and autorouter. | + | In [[lab_4]] we drew the schematic of our board. Now let's do the layout of our PCB. We'll use the layout part of Eagle, along with perhaps the footprint editor and autorouter. This will conclude our exercises with PCB design; after this we'll move on [[dig:# |
Using the {{dig: | Using the {{dig: | ||
Line 8: | Line 8: | ||
- Keep sensitive electrical nodes far away from the noisy digital servo control. | - Keep sensitive electrical nodes far away from the noisy digital servo control. | ||
- Place at least one bypass capacitor near the microphone preamplifier circuit. | - Place at least one bypass capacitor near the microphone preamplifier circuit. | ||
- | - Don't put components | + | - Don't put components |
+ | - Check your board against this [[https:// | ||
You may find it helpful to again scan the {{dig: | You may find it helpful to again scan the {{dig: | ||
Line 17: | Line 18: | ||
When you are finished with your board schematic and layout, send a zip/tgz archive of your design to [[tobi@ini.phys.ethz.ch? | When you are finished with your board schematic and layout, send a zip/tgz archive of your design to [[tobi@ini.phys.ethz.ch? | ||
- | |||
dig/lab_5.txt · Last modified: 2024/02/29 07:28 by 127.0.0.1