dig:lab_4_ardu
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
dig:lab_4_ardu [2016/03/13 17:00] – [Schematics Instructions] tobi | dig:lab_4_ardu [2016/03/13 17:01] – tobi | ||
---|---|---|---|
Line 28: | Line 28: | ||
---- | ---- | ||
- | When you are finished with your board schematic, zip your design and send it to [[tobi@ini.phys.ethz.ch? | + | When you are finished with your board schematic, zip your design and send it to [[kiselev@ini.uzh.ch? |
Line 62: | Line 62: | ||
{{dig: | {{dig: | ||
- | When you are finished with your board schematic and layout, send a zip or tgz archive of your design to [[tobi@ini.phys.ethz.ch? | + | When you are finished with your board schematic and layout, send a zip or tgz archive of your design to [[kiselev@ini.uzh.ch? |
Here you have a screenshot of a possible solution (done using Eagle) that uses 2 layers. Polygons have been used for GND (bottom) and 3.3v (top). | Here you have a screenshot of a possible solution (done using Eagle) that uses 2 layers. Polygons have been used for GND (bottom) and 3.3v (top). |
dig/lab_4_ardu.txt · Last modified: 2024/02/29 07:28 by 127.0.0.1