Differences

This shows you the differences between two versions of the page.

--- dig:lab_4_ardu [2016/03/13 16:57] – tobi
+++ dig:lab_4_ardu [2024/02/29 07:28] (current) – external edit 127.0.0.1
@@ Line 13: / Line 13: @@
 ===== Schematics Instructions =====
-In this exercise we'll draw an Eagle schematic of the microphone amplifier and servo supply / connector from [[lab_3]]:
+In this exercise we'll draw a schematic of the microphone amplifier and servo supply / connector from [[lab_3]]:
 {{dig:micamp.png?800px|Microphone amplifier and servo supply}}
@@ Line 28: / Line 28: @@
 ----
-When you are finished with your board schematic, zip your design and send it to [[tobi@ini.phys.ethz.ch?subject=micboard schematic for Electronics for Physicists II]]
+When you are finished with your board schematic, zip your design and send it to [[kiselev@ini.uzh.ch?subject=micboard schematic for Electronics for Physicists II]]
@@ Line 62: / Line 62: @@
 {{dig:lab4_pcb_template.png ? 200px|template board layout}}
-When you are finished with your board schematic and layout, send a zip or tgz archive of your design to [[tobi@ini.phys.ethz.ch?subject=micboard design for Electronics for Physicists II]]
+When you are finished with your board schematic and layout, send a zip or tgz archive of your design to [[kiselev@ini.uzh.ch?subject=micboard design for Electronics for Physicists II]]
 Here you have a screenshot of a possible solution (done using Eagle) that uses 2 layers. Polygons have been used for GND (bottom) and 3.3v (top).