dig:lab_3a_ardu
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
dig:lab_3a_ardu [2014/03/03 10:54] – created al001 | dig:lab_3a_ardu [2024/02/29 07:28] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Lab 3a - Finishing mic-servo application ====== | ====== Lab 3a - Finishing mic-servo application ====== | ||
- | In [[:dig:lab_3]] you built a microphone preamplifier and you wrote (or modified) code to control the servo motor. | + | In [[:dig:lab_3_ardu]] you built a microphone preamplifier and you wrote (or modified) code to control the servo motor. |
In [[: | In [[: | ||
- | In this exercise you will start from a working example of the mic-servo program and modify it so that it works even if it is not enumerated by USB. | + | In this exercise you will start from a working example of the mic-servo program and modify it. |
Here are the steps of this exercise. | Here are the steps of this exercise. | ||
- | - Download the working example project {{: | + | - Download the working example project {{: |
- | - Build this working example. | + | - Build your own Arduino Sketch for the DSP chain. |
- | - Write it to AVR32 and try to run it. Does it work? It should only work if you are also running rainbow on the host. | + | - Program your Arduino Nano and try to run it. Does it work? |
- | - Once you get the program working, your exercise is to make it work even if rainbow is not running. | + | - If after several tries you give up, you can try {{: |
dig/lab_3a_ardu.txt · Last modified: 2024/02/29 07:28 by 127.0.0.1