dig:lab_1_2014
no way to compare when less than two revisions
Differences
This shows you the differences between two versions of the page.
Previous revisionNext revision | |||
— | dig:lab_1_2014 [2014/02/20 11:53] – [Questions] al001 | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ===== Lab 1: Microcontroller programming setup ===== | ||
+ | In this first exercise let's install the necessary tools and run an example program on a pre-assembled microcontroller board. | ||
+ | |||
+ | By the end of this exercise we should be able to compile the example project //Blink//, program Arduino Nano board with it, then include by yourself Serial interface for helping monitoring for debugging purpose. | ||
+ | |||
+ | - See [[uc2]] for tool installation. | ||
+ | - Arrange a day/time for soldering your own ‘nano’ board during the following week; see [[dig: | ||
+ | - Answer the questions below. | ||
+ | |||
+ | |||
+ | |||
+ | ==== Questions ==== | ||
+ | By next class, hand in (individually) attempts at answers to the following questions, which you may be able answer by reading the {{: | ||
+ | |||
+ | - How much flash/ | ||
+ | - Is there one instruction executed per clock cycle or does it require multiple clock cycles per instruction? | ||
+ | - What is the maximum system clock frequency, does clock frequency have any dependence? | ||
+ | - What is the maximum power consumption of ATmega328P? Which two main parameters are in this matter? | ||
+ | - What is the oscillator start-up time from sleep? | ||
+ | - What is the " | ||
+ | - What is the ADC power consumption? | ||
+ | - What is the maximum PWM output frequency using 8-bit timer/ | ||
+ | - What is the value of the pull-up resistor on the GPIO (when enabled)? | ||
+ | - Does the ATmega family have floating point hardware support? | ||
+ | - Does the ATmega328P have a hardware multiplier? | ||
+ | - And does the Atmega have DSP (Digital Signal Processing) instructions for multiplying, | ||
+ | |||
+ | |||
+ | ~~DISCUSSION~~ |
dig/lab_1_2014.txt · Last modified: 2024/02/29 07:28 by 127.0.0.1